How to Remove a Motherboard

How To Remove A Motherboard From A PC? Detailed Guide [2022]

When you want to add a new casing to your computer or if you want to replace a motherboard, you might have to open all the casings around your system and then remove the motherboard from it.

But this might not be easy as you may think it is. The motherboard is the main board that has all the components and chips attached to your computer. If by any mistake, you damage any of the components, you can suffer a major loss.

In case you are confused to understand how to remove a motherboard from the casing of your computer. Then we can guide you with our article from start to the end to help you fix this problem. You can easily perform this removal of the Motherboard at home if you have the right tools and you know what to do. Make sure you remove the cables and power supply that are connected to a socket and other peripheral devices.

How to Remove a Motherboard From Its Casing

Here, we have steps to guide you with easy procedures for removing a motherboard with tools at your home easily.

Safety First

Before you start the removal process, you need to make sure that you have unplugged all the electrical sockets and any hardware component that may have been connected to a port or socket. Remove all the cables are removed in the first place. Other than this, you can also wear an anti-static wrist strap that can help you to stay safe while checking your system.

Open Your Computer

Now you can start by opening the case of your computer. The side panels are to be removed at first. For this, you have to unscrew the screws that are holding the case firmly into position. If there are clamps that are holding it, untie them and remove each side of the case slowly. After you pull off the side cases, the CPU will look naked from both sides.

Now you can lay down the CPU and make sure there are no sides connected with the casing, and your hands can safely and easily reach the motherboard and its corners.

Removing Hardware

After you have removed the casing, the next step is to remove the hardware from your motherboard, and you have to do it carefully so that you may not damage any sensitive component on the board. You need to know the following components are to be removed first.

  • The main power connector (20 or 24-in connector) comes from the power supply.
  • Memory (RAM).
  • A heat sink (fan).
  • Processor (CPU).
  • Video card.
  • Sound card.
  • Network card.
  • Hard drive (if sitting overtop the motherboard to any extent).
  • CD-ROM or DVD-ROM drive.
  • IDE or SATA cables.

Removing the Motherboard

The last process comes to the removal of the motherboard; in this situation, you have to completely remove the motherboard after you have detached all the cables and hardware components from the motherboard. Remove the screws of the motherboard that are connected to the computer case and then carefully lift the motherboard from it.

You can then replace the motherboard or clean it or do whatever you want to. It can be placed in another by following the same steps in reverse so that you don’t damage anything and don’t forget anything. Keep the components close to your motherboard so that you may not get confused about anything.

Here is a complete Motherboard swapig method and practical guide.


This was a discussion about how to remove a motherboard from a case, and we discussed the easy procedure with simple tips about how one person can remove the motherboard.

The process is simple, and we think you might have cleared your mind with our guide. For more details, join our comment section.

Q1: How do you wipe a motherboard?

Ans: You can clear the motherboard in easy steps.
– Turn off everything that is connected to the motherboard and remove hardware components.
– Also, make sure to disconnect the power and remove all cables from the board.
– Open the case and then find the battery on your motherboard.
– Remove the CMOS battery and wait for about 1 to 5 minutes. Then reconnect the battery.
– Your settings will be restored.
– Put the components back in place and connect the cables. Cover the casing too.

Scroll to Top